The Chance Epoxiglas® Wire-Holding Stick is used on or around energized lines for forming, bending and positioning jumper wires; and for holding conductors during splicing operations. The gripper, equipped with an eye so that other sticks can assist with heavy bending, will handle No. 6 solid copper through 1590 kcmil ACSR. The head of the tool locks in 3 positions…enables lineman to handle conductor from any angle. Operation of the Wire-Holding Stick has been simplified so that it grips much like locking-type pliers. By tightening the knurled nut at the control lever, the wireholding jaws can be positioned to firmly grip the conductor. When this is done, the tightening control lever must be relaxed in a position about 1 inch away from the pole. Then, to secure the grip on the conductor, push lever down to pole; and to release the conductor simply move the control lever all the way up along the rod. The head of the tool locks in three stop positions so that the lineman can engage and position conductors easily from most angles. The knurled screw handle below the jaw opening is used to adjust the head position from straight to right or left. Conductor Capacity: #6 to 1590 kcmil ACSR (0.162″ to 1.5″) Tested to OSHA & ASTM F711 Chance part# C4033068 Arnett part# C-C4033068 Product Type Insulated Hand Tools Tool Type Wire-Holding Stick Length in (mm) 6′ (1.8 m) Storage Bag P643-6 (Bag not included. Must be ordered separately.) Material Type Standard UPC Code 09635923440 Standard Package 1 Standard Package Unit Each Min Order Qty 1 Weight / Ea. lbs 11.76 lbs WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
