AQUAFIN®-IC – Crystalline waterproof slurry 25 KG BAG(S) – SCHOMBURG NASIR & SONS PAKISTAN

Areas of application: • Exterior and interior waterproofing in cellars, lift shafts, foundations, pile caps, floor slabs etc. • Waterproofing containers for drinking and service water, retaining basins, water treatment plants, etc. • Waterproofing beneath screeds (unbonded screeds or floating screeds). An analysis of the water is necessary where the hardness degree is < 3° dH. If applied in containers or in case of water loads with aggressive water or soft water with a hardness < 30 mg CaO per l, a water analysis is always required. The degree of attack is evaluated in accordance with EN 1992-1-1 (Euro Code 2). Aquafin-IC is resistant up to exposure class XA2. Technical Data: Basis: sand/cement, additives Grain size: < 1.0 mm Bulk density: 1.1 kg/l Packaging: 25 kg bags Colour: grey Mix: 25 kg AQUAFIN-IC to 6.75 to 8.0 litres clean water Mixing time: 3 minutes (drill with 500–700 rpm) Pot life: 30 to 60 minutes (at 23°C/60%) Substrate/Application temperature: min. 5 °C to max. 30 °C. Lower temperatures extend, higher temperatures reduce curing times. Impermeability to water in situ in accordance with PG MDS, (10 m water column): passed Cleaning of tools: With water when in the fresh state, remove dried material with ASO-R005. Storage: dry, 12 months when stored in the original unopened packaging. Use opened packaging promptly. Material consumption: Ground moisture/ non standing drainage water: 0.75 kg/m2 in one coat Non-hydrostatic pressure: 1.2 kg/m2 in two coats Rising damp / pressure water: 1.5 kg/m2 in two coats Dry film thickness: min. 0.8 mm–1.5 mm Greater material consumption with uneven substrates is not taken into consideration. Ready for exposure at 20 °C and 60% relative humidity: – to rain after approx. 24 hours – to foot traffic after approx. 5 hours – backfilling the building trench after 3 days – filling containers after approx. 7 days